Cars Getting Stuck At Intersection

[AdvancedApproach]

I use the non-legacy ATLS assets for my intersections and for whatever reason they keep getting stuck. This is at a green light no less. Good thing I took screenshots of the problem because as you can see in my setup everything is how @boat instructs users to get everything functioning properly. In previous versions of Trainz this never occurred. What am I possibly doing wrong?

 

[stagecoach]

Why is the invisible track circular? From the trigger, you only need one each way to the stopper. You don't show the controller settings.

 

[AdvancedApproach]

Why is the invisible track circular? From the trigger, you only need one each way to the stopper. You don't show the controller settings.

 

[stagecoach]

You only have two routes, so three and four are not required. SPL is not used, so it doesn't need to be set. Traffic lights opposite each other can use the same route number. You would only need an extra route number if you were to use the filter lights. SPL over rules the other selections.
Notyh/South is one route East/West is the second.

 

[AdvancedApproach]

You only have two routes, so three and four are not required. SPL is not used, so it doesn't need to be set. Traffic lights opposite each other can use the same route number. You would only need an extra route number if you were to use the filter lights. SPL over rules the other selections.

I'll go ahead and start making those changes right now.

 

[AdvancedApproach]

@stagecoach upon further review I figured out that the traffic will behave in that manner under surveyor mode. After switching over to driver mode the lights, cars and controllers will behave as normal.