Who??? Me???
K&L Trainz Steam Locomotive pics!
- Thread starter stevelerro
- Start date
No, Watemple.
Will told Steve how 1225's tender doesn't have "grab irons" on its tender, and Steve told him to stop pointing out every single detail about the engine.
I wonder if it's post #336 here, but Steve edited it.
I wonder if it's post #336 here, but Steve edited it.
Si, messieur.
Railwoodman
Well-known member
Engine and caboose by K&L. Test weight car by simulatortrain.
Matt
Matt
Railwoodman
Well-known member
Matt
Railwoodman
Well-known member
More fantastic Steam 
Matt
Matt
stevelerro
Owner of K&L Trainz
Do you really think I'd make just the engine by itself?
Itll have the aux and the #9647 tool car as well.
Awesome! LOL Sorry, I was only asking because of the AUX tender you have on your freeware page, which would only be accurate with 1940's and 50's freight trains. That's great, though! I look forward to being able to run the 1218 in Trainz. It's one of my favorite articulated steam locomotives.
Railwoodman
Well-known member
Matt
Railwoodman
Well-known member
Just updated from build 78660 to 80230, for the most part it went well . But I would like to hear from anyone who's done the same. Seem a few more of my K&L engines didn't like my decision to update , J1 ( already knew ) ,A5 ( new ) and a K4 5038 (new) B1 still . I would recommend that you wait till Steve and Bill ether say that their work is compatible before you upgrade ( as I should of ) 
:'( or be prepared to due without for a while.
My newer K&L engines are working great and are impressive work
Merry Christmas
Matthew
:'( or be prepared to due without for a while.My newer K&L engines are working great and are impressive work
Merry Christmas
Matthew
Last edited:
stevelerro
Owner of K&L Trainz
I just got the new SP1 patch installed and also had the same issue with the 5038. I was able to fix it, there was a reference to a smoke point in the config that wasn't in the mesh itself. So that is resolved. I'll send you an updated engine.
I will have to look into the A5.
I started picking the J1 apart to eliminate the boxes in the tender bogies, and try to remove the flying pieces on the engine. Hope to have that resolved during this week.
And I will working on the B1 as well getting that T:ANE compliant.
I will have to look into the A5.
I started picking the J1 apart to eliminate the boxes in the tender bogies, and try to remove the flying pieces on the engine. Hope to have that resolved during this week.
And I will working on the B1 as well getting that T:ANE compliant.