TS2010 Junction 'labels' visible in Driver

[Blackfingers]

I've just built another new tram route in TS2009 and successfully copied it into TS2010 (for me, that's an achievement...).:hehe:
However, all the junction 'numbers' that are usually only visible in 'trackside mode' in Surveyor, also show on-screen in TS2010 Surveyor and when running a session in Driver mode.
I'm sure I've missed turning something 'off' or 'on' somewhere. (I confess these new layers options do confuse me).
Any help much appreciated. Thanks.

 

[EdrickV]

Press Ctrl+H or click the little red button on the bar at the top of the screen. (It's tool tip is "on screen help" I believe.)

Edit: Er, the above is for Driver use. Not sure you can hide them in Surveyor.

 

[Approach_Medium]

Funny how long it took me to find out how to do this. I first noticed in the TS2010 built-in routes that the junction markers did not show in driver, but couldn't find a rule to hide them.
Then, someone here told me about the help button.

In Surveyor, you will only see the markers when you are in the trackside mode.

FW

 

[Blackfingers]

Many thanks, chaps. The red button worked!

IanL.