Avery - Lookout Pass

[rockmongrels]

Ok I have two problems.
1. when I move up to the warehouse the boxcars will not unload.
2. I am disabled and can only hit 1 key at a time, How can I change the defualt Ctrl + Right click to a single key? (so I can see contents inside boxcar or building)

 

[Euphod]

I believe you can add the line " -norightclick " to your trainzoptions file to remove the requirement to use Ctrl and right click.

I'm not exactly sure I have it right, I'll research it more when I'm offline and post back, unless some kind soul can correct me before then.

 

[gremlin1812]

I believe you can add the line " -norightclick " to your trainzoptions file to remove the requirement to use Ctrl and right click.

I'm not exactly sure I have it right, I'll research it more when I'm offline and post back, unless some kind soul can correct me before then.

There was a post by windwalker the other day and the line quoted was "-allownoctrlrightclick" seems to work in my TS10 OK.
Regards
Barrie

 

[Euphod]

Thanks for picking up my slack Gremlin...

 

[kurachka]

Ok I have two problems.
1. when I move up to the warehouse the boxcars will not unload.
2. I am disabled and can only hit 1 key at a time, How can I change the defualt Ctrl + Right click to a single key? (so I can see contents inside boxcar or building)

If I remember correctly, I had same problem maybe not on this route,but try the following,when You don't see unloading activity and You stopped at the right section of the track for unloading, point your mouse on the freight car(s) in ?, click on right button,and it should show if empty or full.Go thru all of them,cause in 1 scenario I had same problem,and after playing around,there was no actual unloading done on the play screen,but somehow freight was unloaded.Good luck.