Program crash when selecting layers

TRS2022 Build 118872
I have several layers in my route. Layers Tab
Using the classical editor, I find when choosing a layer, the mouse can slip and the layer moves near a upper or lower layer. This causes the program to close with no error message. No matter how careful I am, the problem can still happen. The new editor does not do this. However I am still learning this new editor and need both to function without killing the program while doing essential work.

Any ideas. Support doesn't do these questions anymore, even though its a programing issue.

I just ran a test on the same build version (beta 118872) and can confirm your observations. It does not happen in the non beta build 117669.

Put in a bug report at https://n3vgames.typeform.com/to/xRdryu

I will do the same so they will get two reports.

ADDENDUM:

A bit of advice which I learned the hard way. I never do "essential work", such as major route development, using a beta version. I use the non-beta version (117699) for route building and then test the results plus do some non critical "experimentation" in the beta version (118872). Lower frustration and higher sanity levels are the benefits of that.

Thanks. I submitted a report.

Quick response back from N3V QA.

I have confirmed the crash and raised it with devs.

Click to expand...