re post #85 Forester1
Hello Forister1,
If adjusting the height use the third figure (I have shown as 0.900m), it's known as the Z axis.
If adjusting where on the length of the model (I have shown as 2.000m) use the axis known as Y.
If adjusting where on the width of the model (I have shown as 0.991m) use the axis known as X.
The use of a minus figure is needed on occasion.
The other figures shown as 0.0 effect the angle and reverse, and are known as RX, RY and RZ.
Most of the above will adjust most but not all of models on the Axes given in IM.Editor
IM.Editor seems to be unavailable from the Trainz Content Creation page, so if you have it keep it safe.
re posts #86 Thule_P and #87 philskene.
Perhaps some kindly content creator, mayhap ????
Cheers, Ken