Surveyor 2.0 Equivalent to Plateau in Old Surveyor?

[MickC57]

Hi everyone. Fairly new to Trainz (a few months now) but I did start route building with the old Surveyor. I have recently changed over to Surveyor 2.0 for almost everything but having lots of trouble trying to control terraforming.

So my question is, is there anyway to work terrain in 2.0 similar to using the old plateau tool? I figure there probably is, I just can’t seem to find it.

Any help will be greatly appreciated?

Mick

 

[ApproachMedium]

The Grade tool works the same way.

Edit: When using the grade tool like the plateau tool, make sure the "Grade" box has a - in it, otherwise it will apply whatever number is in there as a grade percentage.

 

[pware]

is there anyway to work terrain in 2.0 similar to using the old plateau tool? I figure there probably is, I just can’t seem to find it.

It is the Set Height action in the Brush Ground Height target, both in the Tools Palette.

Then enter a specific height into the Height control.

Then use the brush to "paint the ground" at that height.

 

[MickC57]

Thanks for the help. I will try these ideas. Pware, is there a way to hover and get the height?

 

[ApproachMedium]

Thanks for the help. I will try these ideas. Pware, is there a way to hover and get the height?

You can get the height using the eye dropper tool.

 

[pware]

is there a way to hover and get the height?

Three different methods for doing that are described on the Trainz Wiki at Identifying_the_Ground_Height