Suggestions for Blending Water Effect Layers in Surveyor 2.0?

[maxwerks]

I'm modeling the confluence of two rivers, one brown and silty, the other deep green. I'm using a different water effect layer for each river, and the place where the effect layers bump up against each other looks pretty weird and unrealistic (see image below). Does anyone have tips on how to make them look a little more blended?

 

[Forester1]

Looking at both sides of the green there seems to be some edge lighting effect or something at the edges? Is it due to height differences?

 

[stagecoach]

The two waters must overlap each other.

 

[maxwerks]

Looking at both sides of the green there seems to be some edge lighting effect or something at the edges? Is it due to height differences?

They're both set at the same height. From Stagecoach's suggestion, I think that may be the problem. I'll try making one overlap the other at the confluence and see if that helps.

 

[maxwerks]

The two waters must overlap each other.

They're both set at the same height. From Stagecoach's suggestion, I think that may be the problem. I'll try making one overlap the other at the confluence and see if that helps.

Thanks, Stagecoach! That seems to have done the trick.