azathoth92
New member
I have TRS2006 SP1. I've loaded drewman's excellent CP Escambia Sub route and the two sessions that go with it. The "CP 507 local" session runs great. But the "CP 330 Grain" session will not run in Driver.
The session opens in Surveyor and all of the dependent assests that have errors show up properly in Railyard, and in Surveyor (as far as I can tell). However when I try to do a quickdrive or open the session in Driver it goes to the point where it has painted the HUD on the screen and is about to start rendering the opening scene and then Driver exits and dumps me out to the session menu or where ever I started Driver.
Is there a way to narrow down the session assets to determine what is causing the problem?
Is there something I should look for in the jet log?
I'll appreciate any advice you can give on a strategy for determining the problem.
Thanks in advance
The session opens in Surveyor and all of the dependent assests that have errors show up properly in Railyard, and in Surveyor (as far as I can tell). However when I try to do a quickdrive or open the session in Driver it goes to the point where it has painted the HUD on the screen and is about to start rendering the opening scene and then Driver exits and dumps me out to the session menu or where ever I started Driver.
Is there a way to narrow down the session assets to determine what is causing the problem?
Is there something I should look for in the jet log?
I'll appreciate any advice you can give on a strategy for determining the problem.
Thanks in advance