I've used pathcontrol rule to guide my trains trough certain busy areas , it's a nice thing, but I have a problem...
As many of u certain are familar with it, u know there is 2 modes, blocked and unblocked. The blocked mode locks the line until the train passes trough their signals and switches...(I'm not sure the "unblocked" one does the same). The blocked one wait until the line is green and all switces are in the right state.
Ok..now my question. When the pathcontrol command is set for a path, I see all the signal turn green ( or yellow), and the switches are in the right possition all the way.
But HOW DO I GET MY OWN TRAIN MOVING???, ALL THE SWITCES I HAVE SET FOR IT BLOCKS MY OWN TRAIN TOO, STILL IT HAVE GREEN LIGHT AND THE SWITCHWS ARE SET.
can some experienced traindriver pls explain this...........
As many of u certain are familar with it, u know there is 2 modes, blocked and unblocked. The blocked mode locks the line until the train passes trough their signals and switches...(I'm not sure the "unblocked" one does the same). The blocked one wait until the line is green and all switces are in the right state.
Ok..now my question. When the pathcontrol command is set for a path, I see all the signal turn green ( or yellow), and the switches are in the right possition all the way.
But HOW DO I GET MY OWN TRAIN MOVING???, ALL THE SWITCES I HAVE SET FOR IT BLOCKS MY OWN TRAIN TOO, STILL IT HAVE GREEN LIGHT AND THE SWITCHWS ARE SET.
can some experienced traindriver pls explain this...........
