Moveturntable rule

[briarbank]

Hi all,

I have trainz for mac 1 and 2 also trs2006, and 2012. I was hoping to use the moveturntable rule in conjunction with inputtable. Trouble is that although the moveturntable rule is shown as installed in content manager it does not show up when trying to add the rule in a session.
Any advice would be most welcome

 

[Bill69]

The move turntable rule will not show up until you fill in the required entry in the input table. Edit the input table to include message:- turntable,turntable name, No. of stops. the first word "turntable" must be all lowercase, the turntable name MUST be exactly as you have named the turntable, it is case sensitive, and the number of stops must be exactly as given in the turntable config.txt file.

Cheers,
Bill69

 

[briarbank]

Hi Bill69,
Thanks, finally cracked it thanks to your advise.
Much appreciated.

Regards
Briarbank

 

[Bill69]

No worry advice is free.

Cheers,
Bill69

 

[inprr]

i am having a hard time doing said instructions. where does it go?

 

[Bill69]

Hi inprr,

Have you got the input table available in surveyor? If not go to 'edit session' click on "add" and scroll down till you can select the input table to add. This is what your input table should look like when you have entered the turntable data. The input table will be blank at first, click on "add" to start entering you first instruction.



Cheers,
Bill69

 

[inprr]

ok i have got it added but now its says that an error is in moveturntable. i added >turntable,UB1.73< number of tracks on the laramie roundhouse. am i doing something wrong? -inprr

 

[Lewiscc65]

If the turntable name is UB1 and the number of tracks is 73 then it should be seperated by a "," not a ".".

 

[inprr]

this is what it says> MoveTurntableCommand : Thread Exception: ER_ArrayOutOfBounds, line 84, file moveturntablecommand.gs (1) found out why i had a problem. fixed now. thanks all who help out the people who needed it in this thread