G'day All,
I'm trying to work out if there is a way to introduce a fixed, vertical offset to a spline somehow?
I'm updating an older road to remove the shadow that it casts so I've updated it to version 4.4 to enable the "does-cast-shadows" line.
In it's original version, it seemed to have a line which enabled a 0.4M height adjustment but that tag is not permitted in version 4.4 or higher, so now, where the old road was set to a fixed height on the route, my new version sits below the ground when I bulk-asset-replace it (it's a very large route, so relaying the road manually is not practical).
I'd like to be able to add the 0.4M adjustment back onto the spline. Is there a way to do this in v4.4?
Thanks for any suggestions.
Cheers,
Piere.
I'm trying to work out if there is a way to introduce a fixed, vertical offset to a spline somehow?
I'm updating an older road to remove the shadow that it casts so I've updated it to version 4.4 to enable the "does-cast-shadows" line.
In it's original version, it seemed to have a line which enabled a 0.4M height adjustment but that tag is not permitted in version 4.4 or higher, so now, where the old road was set to a fixed height on the route, my new version sits below the ground when I bulk-asset-replace it (it's a very large route, so relaying the road manually is not practical).
I'd like to be able to add the 0.4M adjustment back onto the spline. Is there a way to do this in v4.4?
Thanks for any suggestions.
Cheers,
Piere.