spline height adjustment

[martinvk]

In S2.0, I set the Tool Properties Height to 3m. I then select multiple spline joints. I use Shift and left mouse click on one joint in order to keep them all selected. The function Apply Height to this Spline Endpoint only adjusts that one joint. Is there a way to adjust them all without selecting them one at a time?

 

[pware]

Instead of selecting multiple spline joints (the endpoints) select the spline segments themselves - hold down the shift key and left click on each individual spline segment to be selected (or double left click on any spline segment to select them all up to the next junction). Then set the height in the Tool Options Palette - in this case type 3 followed by the Enter key or click in the height box and press enter to use the value already there.

 

[martinvk]

Ah, so I was picking the wrong target, instead of the spline joints, I should have picked the segment.

 

[pware]

I should have picked the segment.

Correct. You can select individual endpoints to set their height (or grade) individually but for a sequence of endpoints you must select their segments.