Surveyor cameras not working

Hi, everybody !

Here is an example :



As you can see, this is a static camera that was created in Route Edit mode. It is pointing at the signal and the distance between the two is 50-60 meters. So, as far as I can understand it should start whenever the loco gets near the signal / under the bridge. And that should work in any session.

Well, it doesn't. Never, ever. Same with trackside cameras.

Can you help? Thanks in advance.

PS: I use TRS2019 Platinum, build 110491.

Allo tfr.stmalo
a few questions although they may sound stupid, I have to ask:
-if you placed a camera, do you save and go out of your route then in again?
-do you press 3 camera view in driver, it won't work with 1-cab or 2-tracking?
-camera only work in driver
hope you solve it
greetings GM

I agree with the above. The main point, not explained in your original post, is that cameras only work in Driver.

There is an excellent and extensive guide to using cameras on the Trainz Wiki at http://online.ts2009.com/mediaWiki/index.php/How_to_Place_and_Use_a_Camera

pware said:

I agree with the above. The main point, not explained in your original post, is that cameras only work in Driver.

There is an excellent and extensive guide to using cameras on the Trainz Wiki at http://online.ts2009.com/mediaWiki/index.php/How_to_Place_and_Use_a_Camera

Click to expand...

G.M had found the problem : I was actually in Driver, but I had forgotten about the 3 camera mode.
Stupid of me, of course.

Many thanks to you both.