About the Shinkansen Session announced on page 276 please notice:
There is probably a bug in the SP3 version of the session. After the 3rd station Toshin you will be approaching Hazima with a speed of 220 km/h. The session will instruct you to brake to 170 km/h before the tunnel and 120 after the tunnel and then 70 km/h at 1 km before Hazima. This instruction comes in one message box so you should read it as one continuous braking movement before the stop at Hazima. This is ok. What is not ok though that the junction isn't set. You can check this in the HUD because the Speed limit stays probably at 220 km/h. This is the limit of the through line.
To make most of your session press
J to set the junction ahead of you after passing through the tunnel before Hazima. The Hud should then display a next limit of
70 km/h. This is correct because this is the platform approaching speed.
At Hazima you should stop at the end of the platform.
If you do not set the junction you will pass Hazima. The session will not end though and you could still continuo to Northtropp. But you will miss the Hazima stop and arrive too early in Northtropp. So the session will then not play out correct.
I believe the SP2 version is fine but only the SP3 version is affected. Do not try to import the SP2 version into SP3 as that will cause problems in the route.
I will recheck the SP3 version soon and upload a fix soon but for now you have instructions to switch the junction yourself (it is in an unlocked state)
Sorry for the inconvenience. I swear I tested it again and again but today at driving I noticed that the set junction instruction before Hazima (the junction should be set by a trigger) was not working.
.