Hi there,
I'm a pure dabbler, but I have a lot of fun building routes with improbably steep hills and sending trains up them using the drive command (I'm too much of a dummy to do much else). Normally the trains ignore all laws of physics and happily run up a steep hill just as easily as they would run on flat terrain. I've been doing this for a long time now, most recently with Trainz 22.
But now, the laws of physics suddenly apply and my trains won't drive themselves up steep hills. You might say there's a bit of justice in that, but I prefer my fantasy world where they used to handle it fine! Is there a setting that I can use to go back to the previous situation? Just to clarify - I'm talking about the drive command and not any manual control. Many thanks.
I'm a pure dabbler, but I have a lot of fun building routes with improbably steep hills and sending trains up them using the drive command (I'm too much of a dummy to do much else). Normally the trains ignore all laws of physics and happily run up a steep hill just as easily as they would run on flat terrain. I've been doing this for a long time now, most recently with Trainz 22.
But now, the laws of physics suddenly apply and my trains won't drive themselves up steep hills. You might say there's a bit of justice in that, but I prefer my fantasy world where they used to handle it fine! Is there a setting that I can use to go back to the previous situation? Just to clarify - I'm talking about the drive command and not any manual control. Many thanks.