In this tutorial I will show you how to load three completely different product loads on a single flat car.
Assumptions:
1. The products you want to load allow for a mixed load. How can you tell this? The following line will be in the product load config.txt file for each of the items you want to load: allows-mixing 1
2. You want to load two or three items, each of which may be different from the other.
Items I am using for this tutorial, all of which are on the DLS:
1. <kuid2:439337:100172:5> Flatcar50ft CCLE hw#
2. The following products of mine:
<kuid:439337:107964> Industrial Machine 11-SAP
<kuid:439337:107910> Industrial Machine 1-SAP
<kuid:439337:107913> Industrial Machine 2-SAP
Conditions for this test: I will be loading three completely different items on one Flat Car.
Do the following:
1. In the Surveyor Trains tab click the "?" icon and then click the flat car to open up the properties pop-up dialog.
2. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
3. For the product choose Industrial Machine 1-SAP
4. Change the units from 0 to 1 for that product item.
5. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
6. For the product choose Industrial Machine 2-SAP
7. Change the units from 0 to 1 for that product item.
8. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
9. For the product choose Industrial Machine 11-SAP
10. Change the units from 0 to 1 for that product item.
If you have done everything correctly then the flat car should now look like the following screenshot:
That's all there is to it!
Bob
Assumptions:
1. The products you want to load allow for a mixed load. How can you tell this? The following line will be in the product load config.txt file for each of the items you want to load: allows-mixing 1
2. You want to load two or three items, each of which may be different from the other.
Items I am using for this tutorial, all of which are on the DLS:
1. <kuid2:439337:100172:5> Flatcar50ft CCLE hw#
2. The following products of mine:
<kuid:439337:107964> Industrial Machine 11-SAP
<kuid:439337:107910> Industrial Machine 1-SAP
<kuid:439337:107913> Industrial Machine 2-SAP
Conditions for this test: I will be loading three completely different items on one Flat Car.
Do the following:
1. In the Surveyor Trains tab click the "?" icon and then click the flat car to open up the properties pop-up dialog.
2. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
3. For the product choose Industrial Machine 1-SAP
4. Change the units from 0 to 1 for that product item.
5. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
6. For the product choose Industrial Machine 2-SAP
7. Change the units from 0 to 1 for that product item.
8. In the Max Load 3 section click the "+" icon to open up the products pop-up dialog as shown in the following screenshot.
9. For the product choose Industrial Machine 11-SAP
10. Change the units from 0 to 1 for that product item.
If you have done everything correctly then the flat car should now look like the following screenshot:
That's all there is to it!
Bob