In the Interface settings, one of the options is "Fixed track vertex height.
When this is not checked, track will follow the terrain elevation. In surveyor, the spline points are white circles. If I apply a vertex height value, the spline point changes to a yellow circle and it no longer follows the terrain if that is adjusted. Instead an arrow protrudes from the center of the spline pointing to the actual terrain height above or below the spline.
Is there a way to revert to a white spline circle and have the track again follow the actual terrain?
When this is not checked, track will follow the terrain elevation. In surveyor, the spline points are white circles. If I apply a vertex height value, the spline point changes to a yellow circle and it no longer follows the terrain if that is adjusted. Instead an arrow protrudes from the center of the spline pointing to the actual terrain height above or below the spline.
Is there a way to revert to a white spline circle and have the track again follow the actual terrain?