"Unknown Asset" Blocking Load Of CDP?

[boleyd]

This is not a ROUTE SESSION but the other one!

I made a CDP of a session. At least I assumed it was, "Working Session".
This is the one without the word Default attached to the name.

I load the session's backup CDP with no errors. However, in the program's main menu, only the original Route Session appears.

I have tried repair processes suggested by a kind person of the forum, to no avail. Therefore I accepted that I will have to rewrite the instruction script that was in the "Session". However:

Can an "unknown" error label prevent the data on the backup CDP from loading and subsequently displaying on the Main Menu?

NOTE: The asset is not totally unknown. It's label is known by the Session on the CDP. There is a request there to load that asset that is sent into the working database. That request generates the "Unknown" error label and maybe the failure of the backup.

 

[stagecoach]

Open the edit-config of the session and look for map-kuid. Check to see the kuid of the route it was attached to. If different from the route you are using try and change the kuid to match your route..

 

[boleyd]

After mistakenly displaying the wrong KUID location in the "config" I finally went back to the top and used the correct one. So the fix worked. The route operation directions are ok and functional.

Thank you for your persistence over ignorance.

 

[JCitron]

I've done that before more than once and it's very confusing. It's worse when the KUID numbers are close because I ended up staring at the number and not seeing the mistake.