TRC Signals Driving Me Bonkers

[RepublicDC9]

I've successfully installed these in previous routes, but now every time I go to adjust one of the crossing signals, it somehow "grabs" and adjusts ALL of the asset (the crossing signal in this case) ALL over the train layout I'm working on.

Which means the other crossings end up in the wrong position entirely.

Is there a key to hold down or something to keep the signal I'm adjusting from "attaching itself" to every other like asset throughout the project I'm working on?

Thanks....

 

[skittlekicks]

Are you using Surveyor Classic (S10) or Surveyor 2.0 (S20)? And which version of Trainz are you using?

 

[RepublicDC9]

Hello - I'm using Surveyor 2.0 and Trainz 22, thank you!

 

[JCitron]

If you are using S20, don't double-click on an asset, but doing so in S20 will select all those assets.

 

[RepublicDC9]

Thank you, @JCitron !!! That was the tip I was looking for, and I now have fully working TRC signals on my entire route .