The Kickstarter session was interesting but I tried one of my few industries routes. I removed all the driver instructions, changed them all to Automatic Scheduler and sat back to watch the action. hmmm, not much. I keep see missing junction messages. Using a trackmark, I got the driver to get closer to the red signal which said the line ahead is unsignalled. the next junction is set for the other track and is locked. The other consist also complains about missing junctions.
Compared to the Kickstarter session, I have a lot fewer rules in my session setup. Just three in fact: Startup Options, Driver Setup and Driver Command.
So what are the minimum required rules for TLR to function.
In the TLR documents it mentions
Unless every source - destination set can use an exclusive set of tracks, there will always be times when two trains want to use the same junction. In the past, it seemed to be case of FIFO. Is this not possible with the TLR or still something to be implimented?
Compared to the Kickstarter session, I have a lot fewer rules in my session setup. Just three in fact: Startup Options, Driver Setup and Driver Command.
So what are the minimum required rules for TLR to function.
In the TLR documents it mentions
and if two trains are competing for one junction, a stand-off will occur.
Unless every source - destination set can use an exclusive set of tracks, there will always be times when two trains want to use the same junction. In the past, it seemed to be case of FIFO. Is this not possible with the TLR or still something to be implimented?