train will not move..

[skidmark22]

I have downloaded Ben Neal's N&W Class J 606 from Steammachines.com and I can not get it to move in TS2009. Neither cab mode or DCC. Anyone got any ideas please? It is a good looking engine but not worth much if it will not pull it's own tender. It just sits there and smokes.

 

[rweber95]

The enginespec needs a few adjustments. What is the kuid number of the loco?

Bob

 

[skidmark22]

The enginespec needs a few adjustments. What is the kuid number of the loco?

Bob

96914:6060

 

[NIARTcar]

Brakes are on the left:hehe: Joke


are you using the keyboard or controls on screen?

 

[skidmark22]

Brakes are on the left:hehe:


are you using the keyboard or controls on screen?

If you had read the original post, it says "cab mode" nor "DCC". Neither one works and I did turn the brakes off. I tried moving the train manually and also tried to tell it to navigate to. Nothing gets the engine to move.

 

[NIARTcar]

I havent had a problem with that particular engine from him. You might trouble shoot and try to icsolate your problems, Change the engine spec to another engines' (which does works) and see if you get results.

 

[BobCass]

Hi Skidmark: Open up CM, Open up your Con -fig file through the Explorer ..And change your Kuid No, in your engine spec. to disired Kuid No..This what I have done in the past..


Bob Cass

 

[skidmark22]

Hi Skidmark: Open up CM, Open up your Con -fig file through the Explorer ..And change your Kuid No, in your engine spec. to disired Kuid No..This what I have done in the past..


Bob Cass

Ok, I tried that with terrible results. Now it will not even show up when I try to place it on the track so I sent it along the route of all the other bad downloads which I seem to get more than my share of. Deleted it and the tender. Too bad, it was a nice looking engine. Maybe some of you with a lot more experience at editing will have luck with it. I don't even know where to go look at the engine specs. It is a shame that so many creators put so much stuff out there that needs editing. Kind of narrows down the list of people who can enjoy it.:'( Maybe the problem is TS2009. I seem to get a lot of that.

 

[rweber95]

I edited the enginespec motor container of nwj eng,<kuid:96914:51606> to this:

motor
{
resistance 1.5
adhesion 4.5
maxvoltage 600
maxspeed 30
brakeratio 55000
max-accel 3500
max-decel 1500
throttle-notches 32
axle-count 4
surface-area 80
moving-friction-coefficient 0.07
air-drag-coefficient 0.002
}

to make it run in DCC. I runs in CAB mode for me without changes.

Bob