What am I doing wrong!
In previous versions of Trainz, it was not that difficult to build
a railroad in the sky for aircraft.
It appears to be a different story in TS-12.
I have been laying the track basically at ground level.
Ground level however varies drastically from spline point to spline point.
If the track disappears below ground, I ignore it when laying the track.
At a later time I adjust the height to the flight level I want for the
final version.
This worked fine in TS-2006.
Before I adjust the spline heights, I place an aircraft on the track and
drive it to a Track Mark at the intended stopping point.
Every time, Trainz reports “No Path to Trackmark”.
I have tried several methods to correct the issue to no avail.
Anyone else have success doing this?
Edit: I am using stationmistress track... Green track invisible in driver TS12,<kuid2:515726:4281:1>
-AL
In previous versions of Trainz, it was not that difficult to build
a railroad in the sky for aircraft.
It appears to be a different story in TS-12.
I have been laying the track basically at ground level.
Ground level however varies drastically from spline point to spline point.
If the track disappears below ground, I ignore it when laying the track.
At a later time I adjust the height to the flight level I want for the
final version.
This worked fine in TS-2006.
Before I adjust the spline heights, I place an aircraft on the track and
drive it to a Track Mark at the intended stopping point.
Every time, Trainz reports “No Path to Trackmark”.
I have tried several methods to correct the issue to no avail.
Anyone else have success doing this?
Edit: I am using stationmistress track... Green track invisible in driver TS12,<kuid2:515726:4281:1>
-AL
Last edited: