Strange session and Toggle new message problems

umphies

Member
When I am in Driver in some situations I get a message in the "TOGGLE NEW MESSAGE" box saying:Main browser closed
Whistle page closed
rear code is:
lamp code is:
What do these mean and what do I do to sort them out?


Also I have created a session in surveyor and did something I know not wot and now I have a session which cannot be deleted in the normal way.
There is no little 'c' in the column between route and session for this particular session and it is causing fatal error reports if I try to do anything with it.I would like to get rid of this session without affecting the route and other sessions...How do I do it please?:'(


Thanks in advance...

p.s. uh oh another question from a old fossil....why do rolling stock look distorted sometimes in both surveyor and driver??They seem to go good after a while and then go all squashed and angled again..Is this fixable please??

thanks once again from old grey head...




update: the session problem has fixed itself.There is (was) now a 'c' in the column and I have successfully deleted it..don't know why it went good on its own..still get the fatal error message though . have been told it could be a graphics driver conflict.
 
Last edited:
why do rolling stock look distorted sometimes in both surveyor and driver??They seem to go good after a while and then go all squashed and angled again..Is this fixable please??
That can be caused by insufficient graphics memory. When the complexity of all the visible items reaches a critical point, distortions occur. Assuming that's the cause, here are some possible fixes and workarounds:
  • A better video board with more graphics memory (that's the best answer).
  • Shorter trains, with less variety of rolling stock, and less complex rolling stock.
  • Reducing the graphics resolution in Trainz.
There may be other causes and other fixes. Sorry, I don't know the answers to your other questions.

John
 
Also I have created a session in surveyor and did something I know not wot and now I have a session which cannot be deleted in the normal way.
There is no little 'c' in the column between route and session for this particular session and it is causing fatal error reports if I try to do anything with it.I would like to get rid of this session without affecting the route and other sessions...How do I do it please?:'(....Thanks in advance...thanks once again from old grey head...
Have you tried deleting the session in CMP? And does CMP see any problems with the session?
Mick Berg.
 
As for the distorted looking rolling stock, try setting the "train poly count" setting all the way to the right in the performance settings and see if that dosen't fix it. It worked for me running TRS 2004.
 
Back
Top