Set junction using priority

[peterwhite]

I am looking for a way to set a facing junction by using the trains priority.
Basically I want the junction to set left for priority 2 and right for priority 1.
Is this possible?

Peter

 

[pware]

There is no session rule that I know of that will query the priority level of a consist (but that does not mean that such a rule does not exist).

 

[skittlekicks]

Is the invisible Enhanced Interlocking Tower smart enough to do something like this?

 

[MichelLmbrt]

Perhaps using two AI Routing Priority Markers ( kuid -3 10190 ). One on each track beyond the switch with priority 2 for one and 1 for the other ?

 

[peterwhite]

Is the invisible Enhanced Interlocking Tower smart enough to do something like this?

I use Interlocking Towers intensively but got to the stage where my session would not load. I assumed it was because of all the data involved so I am trying different ways to cut down the number of Towers and paths to see if that is the case.

 

[peterwhite]

Perhaps using two AI Routing Priority Markers ( kuid -3 10190 ). One on each track beyond the switch with priority 2 for one and 1 for the other ?

That would entail using Drive to/via and I only use autodrive. I don't like giving AI the option.

 

[justinroth]

I am looking for a way to set a facing junction by using the trains priority.
Basically I want the junction to set left for priority 2 and right for priority 1.
Is this possible?

Peter

I personally would use enhanced interlocking towers and then mission codes. The switch/route will be set depending on the mission code assigned to the driver.