Protecting double track crossing

ianrein

Member
Hi I. have a problem protecting double track crossing double track
Trainz does not recognise this setup so need a solution
Have tried Interlocking Towers but a train with lower priority was waiting for a train with higher priority to cross
I need a solution that would work like typical signalling so that if junction is clear the train gets a green signal
or yellow depending on state of following signal
I was thinking of a solution where you have a If Signal A is Red B is Green Rule
A being signal immediately before crossing and B being signal immediately before crossing on crossing track
This would be adapted to protect the other paths crossing
I was also thinking if a trigger would work but I have never been able to work out how to use them
If anyone can explain this it might be a possible solution TIA
 
Have tried EIT but train keeps stopping at crossing
For me it seems touch and go whether the train goes through or not
I don't know if it it is possible to have a trigger to do what I suggested in last post0
 
Assuming the ATLS system does the same job I can see how it protects one road or track crossing
but how to protect a double track converging to double track?
Do I need to set this up for each crossing track ie two or can it be done on one?
I need the two tracks working independent of each other but so that opposing tracks have opposite signals aspects and are protected

Please show me how to connect this up as I got lost
looking at video trying to substitute signals for the closing
 
No ASB is completely different. See the following on the DLS.
<kuid2:76656:100119:1> ASB DTT RHM DEMO ROUTE Tane + TRS19
<kuid2:76656:100159:1> ASB DTT LHM DEMO ROUTE Tane + TRS19
<kuid2:76656:100160:1> ASB DTT LHM DEMO SESSION Tane + TRS19
<kuid2:76656:100126:1> ASB DTT RHM DEMO SESSION Tane + TRS19

 
Last edited:
Back
Top