Rogue Vertex Markings

[pitmilly]

When carrying out alterations to a WIP loco shed track layout have been left with three adjacent rogue vertex markings - X X X. There is no visible evidence of any connected track or any other spline related asset to which they might still be, or once were, attached. They appear to be registering at the area ground level which is at 10.00m. I suspect they are the cause of problems with an adjacent turntable. Have been trying to delete them but can't. Does anyone have the solution.

May thanks
John

 

[JCitron]

Press the F9 key until you are in mesh view. It's possible that there's something buried under the terrain. If there is something there and you can't delete it, switch to the Session layer and see if you can delete it there. It's possible you had either selected that layer for something else and forgot to switch back, or you put this down in the Session editor by mistake. Once you delete the asset from this layer, remember to switch back to the Route layer!

I've made this mistake a few times and it's one more thing to be aware of.

 

[pitmilly]

Many thanks John. Problem solved - route/session track mixup as you surmised.

regards

John