New Computer

[BayRidgeRailroad]

I have purchased a new computer... and loaded my TRS2006 program. When I go to enter the seriel code, I continue to get the message that this is already in use. It was... on my old computer (now dead and buried). Does anyone know a solution to this issue.

I am not looking to upgrade. I have spent too many hours on this building my railroad.

Anyone?

Thanks,
Frank

 

[clam1952]

Need to be using the same user name as when you first registered it, as you dont have 2006 alongside your name I'm guessing this is not the user name you originally used. Registration is tied to the user name.

 

[BayRidgeRailroad]

You are correct. It was so long ago that I don't remember the password. I have attempted to retrieve without success. Any hints?

 

[aardvark1]

You are correct. It was so long ago that I don't remember the password. I have attempted to retrieve without success. Any hints?

Hint..............

Contact the Helpdesk...... see button....top right....of Forum Page.

BUT..........TRS 2006 is NOT supported at this time, so you may not get a reply. You may want to start thinking about upgrading to a newer version of Trainz.

Have fun,

 

[tomurban]

Hint..............

Contact the Helpdesk...... see button....top right....of Forum Page.

BUT..........TRS 2006 is NOT supported at this time, so you may not get a reply. You may want to start thinking about upgrading to a newer version of Trainz.

Have fun,

If you decide to upgrade, I recommend TS2010 for compatibility Mode, be sure to save your route as a CDP. That will make importing the route to the upgrade relatively simple. Same for assets. You may have to do some error fixing though.

tomurban