missing levers

[mistra]

In my route when I save a session and reload it later, half the levers of the turnouts don,t work! (unable to plot route etc). The levers are there, but they have two red arrows!!
when I go back to surveyor, everything is ok. When I start the session anew, all is well, the problem happens when I resume the session !
Any idea's?
thks in advance, Han

 

[whyfly2]

Hello Han,

I've had that two-red-arrows problem when I've created new turnouts, and both tracks don't join at the same level or something else was not aligned at the switch. Perhaps you should try deleting one turnout, redoing it, and seeing if that helps.

Art

 

[cascaderailroad]

If the two red arrows show, the lever needs to be moved slightly and dragged into the very center of the switch spline point circle.​

 

[llebrez]

Here is a variation of the problem: You make a route and session. Save to CDP, or in full size file. Move it to an external storage, and then re-load it back. Most of the switches are missing or show the two arrows in red. Try to move them or re-install, and you can't do it. Only way to re-construct is to erase tracks at the switch and re-install them, then the default lever shows and you can substitute it for the original one. On one is fun, but when you have hundreds.. it takes days if not weeks to fix. This using 09. Please don't tell me that in 2010 this flaw has been addressed and corrected... (excuses if I am sarcastic)

 

[BobCass]

llebrez: I would suggest you do an extended data base repair and see if that would help..

 

[mistra]

Sorry folks,
Nothing of the above works. Must be another 2010 quirk, very disappointing.
Thanks anyway for your elp

 

[ef-el]

if you edit the session and works on track ore trackobjekts, then you must merge the "session-layer" into the "route-layer" befor save the session in surveyor (press F6 ...)

sorry for my bad english

 

[mistra]

Hallo Ef-El,
Your answer seems to be the solution !
Danke schoen!:Y: