Forward and reverse views

[Nuttynoah]

hi all

anyone no what the key or keys are you press so you sit in the other end of cab, (if the loco has a cab at each end), looked in the TS2010 Manual under Keyboard Controls, page 47 but not there.

Thank you.

 

[gparker]

Changing ends for driving

ALT-C should do it.
Graham

 

[Retro00064]

hi all

anyone no what the key or keys are you press so you sit in the other end of cab, (if the loco has a cab at each end), looked in the TS2010 Manual under Keyboard Controls, page 47 but not there.

Thank you.

When this feature was introduced back in UTC, you would press the C key on your keyboard while in the Cab view to switch to the other cab (if it is a dual-cab locomotive).

Regards.

EDIT: Looks like gparker beat me to it by one minute! :hehe: I suppose that it should figure that they changed the key-combination for that in the newer versions of Trainz. :hehe: Regards.

 

[rweber95]

hi all

anyone no what the key or keys are you press so you sit in the other end of cab, (if the loco has a cab at each end), looked in the TS2010 Manual under Keyboard Controls, page 47 but not there.

Thank you.

A list of all keyboard commands is in your TS2010\UserData\settings\keyboard.txt file.

Bob

 

[Nuttynoah]

just gone into the manual to write down the keys ALT+C you told me and it is in there, but for some unknow reason my brain was telling me to press shift+c, but your help got me there in the end.

Thank you.

and also a thank you to rweber95, for the folder with all the keyboard commands in it.

did not no that..but then im a bit of a chicken when it comes to going into program folders.

 

[stayontherails]

(first post)

As I didn't know about the shortcuts, I found that when using a XPT with engines at either end I drove the train in reverse, then went to cabin view and the throttle control (I only use DCC) shows as moving forward. External view etc then work as per "normal".