Edit in Surveyor?.

[simfeverish]

First I love Trainz products. I'm currently building a huge route in 2006 and hope to have it finished soon. My problem is in Trainz 12. When I place an object on the base board and go to adjust the height or rotation, the measurements only adjust in feet for up and down or 0.3% for rotation.
How can I change the measurements in inches in height or a smaller degree for rotations?.

 

[pware]

The height measurements are always in metric. You can adjust the height increment or decrement in cms by holding down the CTLR key while you move the object up or down.

 

[danny5]

The same go for rotation
Tested:Height just clicking on a asset will move object up or down in increment of 1.00
Holdind down CTRL will move it in increment of 0.10
Holding down shift will move it in increment of 0.05

Rotate:just clicking will move the aset by 1.00
CTRL will move it by 0.01

 

[clam1952]

The height measurements are always in metric. You can adjust the height increment or decrement in cms by holding down the CTLR key while you move the object up or down.

Or you can hold down the Shift key, which gives you a different increment, one is finer than the other, cant remember which at the moment.

Only ctrl works with rotate though.

 

[simfeverish]

Thankyou, I should have figured that out my self for as long as I've been at this.