Does anyone know what causes a track-spline to break.
This was a route I had imported from TS12 into T:ANE some time ago. I was not happy with the original track and I bulk-replaced it with 'NSW ML Concrete Stain 2.5m'.
Yesterday I did a database repair.
On opening Driver today, I noticed the track-spline had broken. In Surveyor I replaced that section of track, and saved the route and session. Opened Driver again, only to see the same broken section of track. Opening Surveyor the track is broken.
I repaired it and re-saved in a new session, but then in Driver it's broken again.
How can this be fixed. Additional 'saves' doesn't seem to fix it.
Cheers,
Roy
EDIT: I made additional changes to signals, foliage, etc and these items are intact and have been saved.
Track broken.
Track repaired.
This was a route I had imported from TS12 into T:ANE some time ago. I was not happy with the original track and I bulk-replaced it with 'NSW ML Concrete Stain 2.5m'.
Yesterday I did a database repair.
On opening Driver today, I noticed the track-spline had broken. In Surveyor I replaced that section of track, and saved the route and session. Opened Driver again, only to see the same broken section of track. Opening Surveyor the track is broken.
I repaired it and re-saved in a new session, but then in Driver it's broken again.
How can this be fixed. Additional 'saves' doesn't seem to fix it.
Cheers,
Roy
EDIT: I made additional changes to signals, foliage, etc and these items are intact and have been saved.
Track broken.
![2016_12_20_162023.jpg](https://s30.postimg.org/jgwoy1s6p/2016_12_20_162023.jpg)
Track repaired.
![2016_12_20_162046.jpg](https://s30.postimg.org/uuntmzs35/2016_12_20_162046.jpg)
Last edited: