Recent content by gus1911

I have a route where I placed some Boxcar Splines to fill up some large yard space. I want to add more, but I can't find them! I've looked under all the assets. I can't ID them either - nothing shows when I select "Get (category)" & click on the boxcar spline, yet there they are! I'm looking...

Let's suppose 20 coal cars need to be transported from a yard to somewhere 50 miles away. What type engine would be used? Most of the engines in my barn would seem to be overkill for hauling just 20 cars 50 miles.

I gave up on Trainz several years ago because I couldn't deal with Speed Trees. I lost interest completely. Now I've returned and would like to get back to creating sessions the way I used to do it. Problem is - I can't remember how I would set up a session! I've drawn a complete blank...

There's a vehicle here on the Forum for reporting posts, for whatever reason - be they unusually helpful and warrant special notice, or they are offensive or disruptive. Have any of you ever received any kind of response from these phantom people after sending a message? Such as: Thanks? We...

........Sourdough? I can't imagine that he left of his own choosing. I know how much he loved this forum. :hehe:

I've tried the tutotial sticky that explains how to post a pic on the forum. No luck. Could someone please provide the actual coding needed to post a pic on the page? Not the link to the pic, but the actual pic. I want to post a pic in the TS2009 thread - showing the pic is easier than...

I couldn't determine in which forum to put this. I figured this was as good as any. I'm deadly serious about this, and I'm sure there are others of you out there that feel as I do. Trainz and hot coffee go together like bread and butter. When I run Trainz, I need my cup of HOT coffee there...

I have an enormous route. Takes several hours just to go from one end to the other. How can I easily delete large chunks from both ends, and save only the middle section? I'd like it to end up as a 35 to 50 mile route instead of the monster that it is now. I know I can lop off boards one at...

I want to make 90 degree corners on my fences, but unless I separate the corner posts, they snap into a curve. I know you can make 90 degree corners where the corner posts are joined because I have routes that show it done that way. How's it done?

I believe it was in the old forum that I saw a reference to "spinning textures" in surveyor. What is this? And how is it done? What's the effect?