I canot ge the built-in central portal control to work. This is what I did and this is what happens.
I create a new route and session on a new single baseboard. I lay several pieces of track and attach the built-in portal <kuid-25:1265> to the end of the track. I place a track mark at the other end of the track and call it test.
I now edit the central portal control. I assign a locomotive, a driver and give it instructions to drive to "test". The central portal conrol assigns this to portal 1 and index 0, since this is the only portal I have.
I save this route and session and exit. I then re-enter the session. When I now go to edit the central portal control I find that it indicates Index 0 and portal "ERROR" instead of my portal 1.
What is going wrong here?
I create a new route and session on a new single baseboard. I lay several pieces of track and attach the built-in portal <kuid-25:1265> to the end of the track. I place a track mark at the other end of the track and call it test.
I now edit the central portal control. I assign a locomotive, a driver and give it instructions to drive to "test". The central portal conrol assigns this to portal 1 and index 0, since this is the only portal I have.
I save this route and session and exit. I then re-enter the session. When I now go to edit the central portal control I find that it indicates Index 0 and portal "ERROR" instead of my portal 1.
What is going wrong here?