R roca999 New member Jan 12, 2019 #1 The Inputtable rule seems to have disappeared from the Driver Command properties selection. I see it is a built in asset and shows as installed in CM. Did something change as far as setting up turntables in TRS19? Please help...
The Inputtable rule seems to have disappeared from the Driver Command properties selection. I see it is a built in asset and shows as installed in CM. Did something change as far as setting up turntables in TRS19? Please help...
S stagecoach 75377 Jan 12, 2019 #2 Its not a driver command its a rule and has always been so. Open session and add rule. Move turntable is a command.
Its not a driver command its a rule and has always been so. Open session and add rule. Move turntable is a command.
P pware Trainz Veteran Jan 12, 2019 #3 Input Table Rule at http://online.ts2009.com/mediaWiki/...By_Categories_With_Properties#InputTable_Rule MoveTurntable driver command at http://online.ts2009.com/mediaWiki/index.php/Driver_Commands_List#MoveTurntable
Input Table Rule at http://online.ts2009.com/mediaWiki/...By_Categories_With_Properties#InputTable_Rule MoveTurntable driver command at http://online.ts2009.com/mediaWiki/index.php/Driver_Commands_List#MoveTurntable