Session - Endinburgh to Dundee Sleeper
Route installed successful. First impression was that it looked good and the opening sequence was impressive.
Drove to 1st stop at Haymarket Central. Very difficult to maintain schedule, certainly on 1st attempt!
After leaving Haymarket the following messages appeared before arriving at Inverkeithing:
Unable to plot route - Junction is missing lever after junction KIRKCALDY SOUTH J10
Unable to plot route - Junction is missing lever after junction 1935996
After travelling across the Firth of Forth bridge and driving through North Queensferry you enter the tunnel. The North portal of this tunnel is sitting too high.
At Inverkeithing you are asked to stop train just short of signalbox. Mileage stop at 13.6 miles. However there is no indication of trip log, that used to be in the HUD, that indicates just how far you have travelled.
When allowed to depart Inverkeithing, signal 88540 does not give a green so if you try to pass it you receive a SPAD and the session finishes. Looking at the junction, 298512 in Surveyor, just after the signal, it is just noticeable that the trackwork has been incorrectly installed such that if the point motor is showing to the right you actually travel onto the left branch which is occupied. This needs to be corrected before the session can be completed.
If you look closely at the screenshot you can actually see 2 tracks going from the point motor and the one on the right finally goes back across to for the branch line.
Will now try the Dundee to Edinburgh session.
Route installed successful. First impression was that it looked good and the opening sequence was impressive.
Drove to 1st stop at Haymarket Central. Very difficult to maintain schedule, certainly on 1st attempt!
After leaving Haymarket the following messages appeared before arriving at Inverkeithing:
Unable to plot route - Junction is missing lever after junction KIRKCALDY SOUTH J10
Unable to plot route - Junction is missing lever after junction 1935996
After travelling across the Firth of Forth bridge and driving through North Queensferry you enter the tunnel. The North portal of this tunnel is sitting too high.
At Inverkeithing you are asked to stop train just short of signalbox. Mileage stop at 13.6 miles. However there is no indication of trip log, that used to be in the HUD, that indicates just how far you have travelled.
When allowed to depart Inverkeithing, signal 88540 does not give a green so if you try to pass it you receive a SPAD and the session finishes. Looking at the junction, 298512 in Surveyor, just after the signal, it is just noticeable that the trackwork has been incorrectly installed such that if the point motor is showing to the right you actually travel onto the left branch which is occupied. This needs to be corrected before the session can be completed.
If you look closely at the screenshot you can actually see 2 tracks going from the point motor and the one on the right finally goes back across to for the branch line.
Will now try the Dundee to Edinburgh session.
Last edited: