Vincentrh trigger system issues...

rr325

New member
Hello all,
I am making a crossing near a yard with vincentrh's trigger system. But when I run a train through the crossing, the gate lowers, but the lights don't flash and the bell doesn't ring. :'(
Thanks in advance,
rr325
 
Yea he knows about the issue, he doesn't know the code used by the signals and his system doesn't communicate correctly with Andi06's system.
 
Yeah, I was using atls, but the crossing is near a yard, so trains would not run all the way through, so the crossing would just keep going even after the train had cleared the trigger.
What crossings work with his system?
 
Yeah, I was using atls, but the crossing is near a yard, so trains would not run all the way through, so the crossing would just keep going even after the train had cleared the trigger.
What crossings work with his system?

I use the BNSF50's crossings.

You are using the 2 or 4-way setup? I think that maybe what's needed for the yard throat. Maybe even put the trigger-things in a bit closer to the crossing its self so the train can clear them completely, otherwise the gates will remain down. I had to fiddle with something like this for an active siding I setup.

John
 
I tried a 2 trigger set-up, but the crossing wouldn't turn off...
Oh well, I'll keep trying :)
Which crossings work w/ vincentrh's system?
 
Sorry I can't help you with that...

Have you tried setting the trigger radius to something smaller so that the train can sit there on in the yard without reacting with the trigger?

John
 
Back
Top