Turntable issue

[Yorkshire]

2 of my layouts seem to have developed a problem with turntables. Basically, when doing a turn, the turntable track does not align with the height of the joining tracks, it sits slightly higher, consequently no loco can either be driven on to it or sent via a drive to command. It gives a message no route found. The only way to resolve this is to keep turning the table until it clicks in place. I changed turntables from the NSW to the AUS 2 and just discovered same issue. I am using SP2 build 110491. Not sure whether its a corruption on my computer, the programme itself or ....?


Any ideas or anyone experienced similar.


Thanks


Yorkshire

 

[stagecoach]

Had this happen and just replaced the old one with the same but new one. Renamed all to what was there originally. This may be linked to the same problems industries had where the track was separated from the asset. Mostly this cured the problem as my turntables had rotated themselves and the track was all over the place.

 

[Yorkshire]

Thanks, certainly on the AUS 2 turntable, the track totally disappears until it meets the next connecting track. I did replace the NSW turntable on my Callingworth layout - same problem! Oh the trials of Trainz at times. I had thought of doing a fresh installation of Trainz, but from what you say, I'd possible have the same issue repeat.