tunnels not working in tc1+2 like they used to

misterchugg

Active member
hi all

i am having a problem with that my tunnels all look funny after i had to reinstall tc 1+2

either they show blue empty or they are overgrown

check pics please and advise what i am doing wrong

i have deleted them and reinstalled from a save disk

still the same problem

i hope somebody knows how to help me

thanks for your help
ron
http://i114.photobucket.com/albums/n...ajontunnel.jpg
http://i114.photobucket.com/albums/n...oldtunnel1.jpg
http://i114.photobucket.com/albums/n...mas/tunel3.jpg
http://i114.photobucket.com/albums/n...nelproblem.jpg
http://i114.photobucket.com/albums/n...unnel1dark.jpg
 
You need to start with the tunnel portal's (in object menu). then add the tunnel bore (spline menu) then add track . cover hole with grass spline.
 
You can find ready made tunnels in the track menu,( euro,qr stone,1&2) but they are a bit rubbish. Using the spline method gives much better results.
 
hi paul
i cannot find any tunnel bore splines in tc 1+2

can you give me some kuids numbers so that i can chase them down please

thanks
ron
 
Try <Kuid2:60850:37902:2> & <Kuid2:60850:37903:3>. I am using TC3 don't know if they are in TC1&2. I think they were also built in to TRS06 ,if so you could inport them to TC1&2 if you have it.
 
Just searched the DLS for ''tunnel'' and found lots of tunnels,(877 results)
Don't forget to tick all boxes from TC1&2 down and tick on description
Everything from TC1&2 to preSP3 trainz should work, hopefully.
You might also try looking for TRS2004/06 in the bargain bins at local
shops i picked up a copy of 04 for £1.00, at poundland.
 
Last edited:
hi paul

i have pulled down a lot and find they are the same

i still get the open effect like i did before

i found a brick tunnel that is good and that will do me

thanks for all your help
cheers
ron
 
Back
Top