Triggers or rule help please

[BRClass66]

Hi
sorry but i posted this on another thread that i shouldnt have done.


just wondering is there a trigger rule/setting that can change a signal to red...then set another trigger to set it to green..(.i know of one that changes it to red but not green)...what im trying to do is when a train passes a side junction in reverse it will set the signal to red and stop others trying to access this line..which has 4 other junctions on it...then when he pulls out with its load it hits another trigger that changes the signal to green and lets other train carry on.

Brad.

 

[Capt_Haddock]

Brad
Not sure about setting signals but there is a "control junction rule".

This gives a driver control over the setting of a junction. If your driver invoked this rule by holding the junction leading out of the siding, the junction would in turn hold its protecting signal at red until you allowed the driver to relinquish control of the junction.

Regards

Chris

 

[BRClass66]

thanks chris for you reply,

i had looked at control junction rule ...but in not much depth..and truthfully didnt understand it...but now you have brought it up i shall give it a try..
thanks again and ill reply if it works

brad

 

[BRClass66]

nice try but didnt work ..its for monorail junctions This rule controls the execution of all junction animations

but thanks anyway

brad

####sorry it was "junction control rule" i looked at not "control junction rule" tried to find control junction rule but no download to be found...could you tell me where you got it from please?

brad

 

[trev999]

"control junction rule" tried to find control junction rule but no download to be found...could you tell me where you got it from please?

brad

When searching, tick the 2004 box

ControlJunction <kuid:131986:1011>
Switch Junctions <kuid:122381:10010>
Set Signal rule <kuid:47662:20001>

I also have a "Set Signal State" driver command which I wrote.

Trevor

 

[BRClass66]

thanks trevor..

found it ...just going to try it.

brad


ps. cant find the "Set Signal State" you wrote on there...and i ticked all the boxes.

brad

 

[trev999]

ps. cant find the "Set Signal State" you wrote on there. brad

It is not on the DLS, I wrote it myself but it is not uploaded. If you want it, send me an e-mail so I can send it to you.

Trevor