TOTAL NOOB to ATLS system in need of major help! Warning large Pics.

[montanawestren]

Hi yall,
im working on the BNSF stampede Sub and im setting up BNSF50's stand alone crossings because of the angle of most of the crossings. So ive done some research and tried my best to no avail. So first I set up the Crossings:

Uploaded with ImageShack.us
Then I put in the traffic stoppers:


Uploaded with ImageShack.us
Then everything else and set the channel to 1:


Uploaded with ImageShack.us


Uploaded with ImageShack.us
Then I go into driver and nothing works:


Uploaded with ImageShack.us


Uploaded with ImageShack.us
Can anyone please help?
MTW

 

[mikeman]

Looks like you didn't connect the roadway to the traffic stoppers. Might try that first and see. Also you will want to have two of the slaves, one for the crossing signals and one for the stoppers.

 

[NCkilla333]

Triggers

A screen of your triggers might help. They are the hardest to set up. Also take note that the settings save to the session not the route so if you have changed sessions make sure that you settings are even set at all. Again post a pic or just a readout of your settings for the triggers and for that matter your controller and slave as well. And I personally don't see why you would need two slaves. I never use more than one.

 

[NSSD70MAC]

i know i tryed it crossing track

reason the ajs wire crossing track need wireless request wire AJS

 

[amrail2000]

Using the Question mark did you configure the ATLS controller, Slave and ATLS triggers. If you forget even one then it will not function. I've used the ATLS system so much that I configure it in my sleep. Also make sure you set the Controller and slave to LCM (Level Crossing mode). See the pics below (please note: In the first pic it should read LCM not LVCM. Error typed from being way to tired)

 

[madncan52]

Could just be my old eyes, but I don't see where you connected the track ends to each other with invisible track. Won't work if you don't do that.

 

[amrail2000]

Could just be my old eyes, but I don't see where you connected the track ends to each other with invisible track. Won't work if you don't do that.

Hello old friend, yes they are connected with the invisible track. BTW I used S_Track_Invisible from olegkhim.

 

[frogpipe]

You only need invisible track to lay over the visible track of a crossing - that is an asset that has track, road, and gates. When using stand alone gates, the only use for invisible track is to "wire" the Slave to each signal and the traffic stopper(s).

 

[TheRichMan]

\

This is how I learned

 

[frogpipe]

See if this helps, 3 different ways to set them up in a route - just Quickdrive to see what it does and Edit in surveyor to see how it was done.

http://sourcebox.federalproductions.com/ATLS Demo.cdp <- Right Click and "Save As"

 

[jordon412]

Go into TS12, go to 'surveyor', select 'Mojave Sub', and select 'Edit Route'. Check out how they set up the ATLS system and just copy what they did on your route. That's how I learned it.