I edited the config.txt of an old steam model (<kuid2:142675:500010:1>, trainz-build 2.9) by giving it the enginespec of a newer loco (trainz-build 3.7). It now runs very acceptably, with <kuid:248163:100783> as its enginespec.
When running in realistic mode, I use keyboard letters. I'm not using the numerical keypad. Brake (Q, A), cutoff (F, R), regulator (W), injectors (I, O) all work alright. A couple of keys however are not responding, or are responding in unexpected ways:
On other steam locos in the same session all keys work as they should. I know that using 2.9 build locos in TANE SP4 is asking for trouble. Still, I would like all keys on the modified loco to work.
Anything I can try? Suggestions would be appreciated.
When running in realistic mode, I use keyboard letters. I'm not using the numerical keypad. Brake (Q, A), cutoff (F, R), regulator (W), injectors (I, O) all work alright. A couple of keys however are not responding, or are responding in unexpected ways:
- S returns the regulator to 0, instead of taking it back a notch at the time;
- Spacebar adds coal to the fire only once, leaving the firedoor open, then ceases to respond. Ctrl-rightclick informs me that the loco still has almost 90% of its coal on board. The Coal slider does not appear to have any effect either.
On other steam locos in the same session all keys work as they should. I know that using 2.9 build locos in TANE SP4 is asking for trouble. Still, I would like all keys on the modified loco to work.
Anything I can try? Suggestions would be appreciated.