No default surveyor session rules.

[steelherd20]

Im trying to build a route but when i try to add drivers to my trains by clicking on edit session rules, there is no session rules. Everything is blank. Most of the routes are just like this. When I add Driver setup or other options theyre completely blank. Can anyone explain whats going please?

 

[steelherd20]

Also....

This is only in TRS 2006. I tried TRS 2004 and the session options are all there.

 

[ColPrice2002]

Typically this is a symptom of TRS 2006 with SP1 added - but not following all the instructions exactly.

Can you post your "build number"? -

Regards,

Colin

 

[DR_jones]

HIa i have the same problem Build No 3092

 

[Captain_Collins]

The solution to this is to uninstall and reinstall TRS2006 & SP1, following the instructions in the FAQs, tips, and tricks section of the TRS2006 sub forum EXACTLY.

 

[Smileyman]

Agreed!

The only times I've seen this problem is when someone installs Trainz or a Service Pack without following the instructions explicitly (leaving the Anti-Virus running for instance).

Time for a reinstall I'm afraid.

Smiley.

 

[0099]

(leaving the Anti-Virus running for instance).

Really ive never turned off my Anti-Virus while installing trainz and ive never had anything wrong

 

[Smileyman]

Really ive never turned off my Anti-Virus while installing trainz and ive never had anything wrong

Then you've been very lucky.
Do a search on these forums and you'll see that it's caused a lot of people a lot of problems.

Maybe your Anti-virus/Firewall settings aren't too strict, and whatever it is that trips up the installation gets through them without problem because of that.

Smiley.