Looking for Y-intersection ( road)

[belgian46]

Hello,

I have been looking for a Y-intersection ( road ) on the DLS but was not successful.

Does anyone know where I can find a Y-intersection ( road )?

I would like to use a Y-intersection together with the Yarn-roads/intersections/ etc ...

Best regards

Kurt :wave:

 

[GP30Fan]

Y Intersection 1,<kuid2:87907:23191:1>
Y Intersection 2,<kuid2:87907:23192:1>

-AL

 

[belgian46]

Y Intersection 1,<kuid2:87907:23191:1>
Y Intersection 2,<kuid2:87907:23192:1>

-AL

Hello Al,

Thank you for your reply. I saw both on the DLS. However, they are both road signs.

I'm looking for the Y-roads.

Best regards

Kurt :wave:

 

[fran1]

Do a cm search for keyword=intersection, look for the angled ones by tlanders. Not quite Y but close.
kenchiro does 1 but it's a 4 lane.

 

[GP30Fan]

My mistake... and I knew the name was angled and not y intersection.

Angled Road Intersection with Sidewalks,<kuid2:52519:50821:4>
Angled Road T Intersection with Sidewalks 1,<kuid2:52519:50822:4>
Angled Road T Intersection with Sidewalks 2,<kuid2:52519:50823:4>
Angled R-L T Intersection with Sidewalks 1,<kuid2:52519:50831:4>
Angled R-L T Intersection with Sidewalks 2,<kuid2:52519:50832:4>

-AL

 

[belgian46]

Hello AL, Fran1

Thank you for the extra info. I didn't know those Y-roads were called angled roads. So I learned something about the specific term.

I have checked some angled roads and in my test-route I noticed something very odd

The cars on those angled assets are behaving in a strange way


Screenshot 1

Have a look at the position of the red car

The red car is sliding from top of the angled asset until it reaches the yarn-road ( then it turns to a normal riding position ( see screenshot 2 ). On all angled assets used, I had the same situation.

Best regards

Kurt :wave:

 

[GP30Fan]

I think I remember having a similar problem.

I use that asset in a couple locations. My fix was to add an attached mesh of my own
creation and modifing the config to accommodate the addional mesh.

If you PM me with you email, I'll send you the attached mesh and config.

-AL

 

[belgian46]

I think I remember having a similar problem.

I use that asset in a couple locations. My fix was to add an attached mesh of my own
creation and modifing the config to accommodate the addional mesh.

If you PM me with you email, I'll send you the attached mesh and config.

-AL

Hello Al,

PM has been sent.

Best regards

Kurt :wave: