ATLS Traffic Signal Problems in Trainz Plus 2022

[trainguy77]

Looking for some wisdom on ATLS Traffic Signals. I run Trainz Plus and can't get ATLS Traffic Signal to stop traffic.
I'm using Road UK 8m for a way intersection. Difficult to find an appropriate intersection but using UK Roads 8m - X Roads. Traffic runs ok on both cross roads.
The ATLS Controller TRS 19 operated the traffic signals correctly. Using the ATLS Traffic Slave does not work. For some reason I cannot add the preferred ATLS Slave Trigger TRS 19 unless I add the ATLS Traffic Slave first. Then it loads the Slave Trigger on top and both show as Slave Trigger! Wierd. I'm also using two ATLS Traffic Stoppers, placed in the middle of the intersection as per tutorials. Cars run, signals change, but traffic does not stop.
Anyone had similar problems or have suggestions as to what I'm doing wrong?

 

[gt350]

Might not fix your issue but when I use ATLS traffic signals I don't use roads or intersections with traffic. Make my own roads or roads without traffic. Solved a lot of issues.

 

[stagecoach]

The slave is the older system and the trigger is the new one. The old one uses an invisible engine while the new one only sends a message. All assets must be named and no two assets can have the same name.

 

[trainguy77]

Might not fix your issue but when I use ATLS traffic signals I don't use roads or intersections with traffic. Make my own roads or roads without traffic. Solved a lot of issues.

Thanks. I'll give that a shot.

 

[trainguy77]

The slave is the older system and the trigger is the new one. The old one uses an invisible engine while the new one only sends a message. All assets must be named and no two assets can have the same name.

Thanks for the input.