Building a model railway route where the main terminus is over two lower levels of other lines, in tunnel.
To avoid issues with splines at the upper level dropping down and connecting to the lower level, decided to create the terminus on a separate layer. Main route layer locked and I dropped into the new Terminus layer. As an experiment, I just tried to attach a track to a piece already laid in the main layer and it still joined. Oh dear, so much for layers.
Mind you, previously I had already encountered the Basemap, on its own locked layer, still moving up and down when I increased the terrain height in the route layer..
Open to any suggestions how to overcome this.
To avoid issues with splines at the upper level dropping down and connecting to the lower level, decided to create the terminus on a separate layer. Main route layer locked and I dropped into the new Terminus layer. As an experiment, I just tried to attach a track to a piece already laid in the main layer and it still joined. Oh dear, so much for layers.
Mind you, previously I had already encountered the Basemap, on its own locked layer, still moving up and down when I increased the terrain height in the route layer..
Open to any suggestions how to overcome this.
Last edited: