Now this is crazy I have 3 computers trs2006 installed on all 3 and also have trs2009 installed and now none of the junctions with connect properly just doing a test routes on all 3, did Auran do something because I have 3 trs2006 installed on 3 different computers. My newest computer is 3 days old it was a barebones I put it together just for this game. so the new computer is fresh install with the service pack. it don't make sence that none of the test routes will connect juntions, i get the same message no path found.
Juntions Part 2
- Thread starter BThompson
- Start date
Well normally when I'm building a route and put in a siding the track connects like it should, but what is confusing me this has happened over the last fews days so tonite I tried my other computer to just test a quick junction and when I send a train to the track mark there is no path to destination, I have been working on a route and everything has been doing good when I test it, but now when add to the route I been working with the junctions do not line up I'm confused. I really don't know how to explain it. Suppose you have a straight track click in the middle of the track and lay down a siding it just doesn't blend in so there is a break in the track for some reason all my trainz games is doing this.
just to be clear here are you using the Plus sign ( ADD New track) to connect the siding ?
when u drag and existing track to another even if it snaps in like normal TS will not auto place a switch levers and it will not function and cause the the no path message. check all your track for levers also
when u drag and existing track to another even if it snaps in like normal TS will not auto place a switch levers and it will not function and cause the the no path message. check all your track for levers also
Are they networked? If so you could be loading the program from one computer all the time. Your spline circles should be Yellow which donates you have set the spline height. When they are white you could have one rail underneath the other thereby causing the no path message. This no path message can also be thrownup if your lever is in the wrong place in relation to the centre of the spline point. These and a few others are reasons I asked for a screenshot
Bill69
That's OK, no problem. Did my screenshot help?
There is a thread near the top of the forums, a sticky, that explains how to post screenshots.
Here http://forums.auran.com/trainz/showthread.php?t=3374
Cheers,
Bill69
There is a thread near the top of the forums, a sticky, that explains how to post screenshots.
Here http://forums.auran.com/trainz/showthread.php?t=3374
Cheers,
Bill69
Last edited: