Junction operation in saved driver session.

[bhumph1]

I added a small yard with new junctions in my primary session. When I "drive session" everything looks and operates fine. But when I save it to the "save driver session " and resume session, the junctions no longer operate. I have reworked the junctions following all the advice in "Working with track and switches" to no avail.What is it that I don't understand?

 

[fran1]

Are you getting 2 red arrows, no arrows ?

 

[bhumph1]

junction operation in nsave mode

No arrows until you place curser on the junction---then 2 dim red arrows.