Ian_Coleman
New member
I'm building a layout in Surveyor. I placed a single train in place to test out what I had been building. I gave it a simple route to follow. I then saved before going into Driver, as per normal.
I then carried out my test run in Driver, and returned to Surveyor without saving, which again, is normal procedure. I then continued working in Surveyor, and saved again before closing the program down.
This is something I must have done a thousand times in TRS2004, but today I was working in TRS2006.
When I re-opened the program later, and went into Surveyor, I could see that the train had diappeared, and so had the schedule. When I went into Driver from Surveyor I was informed that I could not enter Driver as no Train had been placed!
Has anyone else had this problem in TRS2006?
I thought the procedure was exactly the same as in TRS2004.
Ian
I then carried out my test run in Driver, and returned to Surveyor without saving, which again, is normal procedure. I then continued working in Surveyor, and saved again before closing the program down.
This is something I must have done a thousand times in TRS2004, but today I was working in TRS2006.
When I re-opened the program later, and went into Surveyor, I could see that the train had diappeared, and so had the schedule. When I went into Driver from Surveyor I was informed that I could not enter Driver as no Train had been placed!
Has anyone else had this problem in TRS2006?
I thought the procedure was exactly the same as in TRS2004.
Ian