HELP junction auto drive navigate 2019

[goomermatt]

Hi
I am making an airport but am getting strange happenings.
I have set up two gates with track marks (gate 1 gate 2 )
They are off two separate junctions.
In AI I tell the plane to navigate to TM (gate 1) it sets the junction ok has a green signal but stops at the junction and will not proceed.
If I then delete navigate and enter AUTODRIVE command it continues to TM
The second TM (gate two) works fine.
I have deleted the TM and replaced it still the same
I have also Made a new one board route with the same junction's etc and planes that route is doing the same
Hope this makes sense.

BUILD 110491
Thanks for any help

Matt

 

[pware]

What do you have at the end or terminus of those two "gate branches"? Are they terminated by signals i.e. invisible signals or similar?

 

[goomermatt]

hi yes invisible signals and the speed stutters before stopping at junction

 

[goomermatt]

just a update having to set both junctions now in right direction and Auto drive to TM

 

[goomermatt]

Hi all figured it out I had pushback tractors pasted the TM
I put a invisible junction past the TM and set the junction so the plane could not see the pushback.
now works fine
:hehe:
Thanks for your help
Matt